Registration Date: 12-05-2018
Date of Birth: Not Specified
Local Time: 09-23-2021 at 11:08 PM
Status: Offline

hdjk656's Forum Info
Joined: 12-05-2018
Last Visit: 12-10-2018, 02:03 AM
Total Posts: 0 (0 posts per day | 0 percent of total posts)
(Find All Posts)
Total Threads: 0 (0 threads per day | 0 percent of total threads)
(Find All Threads)
Time Spent Online: 2 Minutes, 31 Seconds
Members Referred: 0
Reputation: 0 [Details]

hdjk656's Contact Details
Email: Send hdjk656 an email.
Private Message: Send hdjk656 a private message.
Additional Info About hdjk656
Location: http://www.cementsandwichpanel.com/wall-panel-installation-accessories/
Bio: ZJT, polymer anti-crack mortar powder is a kind of grey color (white) solid powder. It is ordinary Portland cement, dispersity to latex powder with relative auxiliaries, anti-crack material and mixed with quartz sand and so on, has a good cohesiveness, crack resistance to impact and hydrophobic.
Anti-cracking Polymer Mortar For EPS wall Panel
ZJT polymer anti-crack mortar powder is mainly used in powder polystyrene particles, inorganic insulation mortar, foam concrete external wall thermal insulation system, the type with alkali grid cloth protecting enhance the effect of heat preservation system. Its good crack resistance and impact resistance of hydrophobic ensures the safety performance and service life of the insulation system.
Product advantage
Low water absorption, have a certain breathing performance
Inorganic material is given priority to, long durability
Suitable for waterproof coating or coil cannot apply
High strength, excellent bonding performance, strong bond with concre
Outside after construction decoration materials broad spectrum compatible, coating, brick, or other material can be construction.
Directions for use
1. This product with clean water into a thick paste, water cement ratio of 0.22:1 should be used up within 2 hours after mixing.
2. Two plaster interval shall not be less than 24 hours, such as high degree of dry before plaster matrix to be water wet.
3. Usage: such as hang embedded alkali grid cloth materials 5-6 kg per square meter, such as hanging embedded hot dipped wire mesh per square dosage 8 to 10 kg.
1. The construction environment and the temperature of the wall at the grass-roots level can not less than 5 ℃, wind below level 5, construction to avoid rainy day.
2. The construction is completed, we should pay attention to product protection, after waiting for the desired intensity, before being under construction.
Technical parameters
Need waterproof concrete base and outdoor structures on the surface of the concrete moistureproof,
waterproof construction. Such as: wall ground, swimming pool, drains, tunnels, underground parking, roofing, etc.
Vibration place waterproof construction and coil or waterproof coating combination effect is bestWall Panel Installation Accessories factory
Sex: Undisclosed